Storm Water Couple - Why Is It So Expensive

Cam Lock Couplings are commonly used in Malaysia to connect the drainage pipe fittings of storm water drain systems to the main line. These pipes are usually constructed from clay or slag as the material of application and these can be found all over the country. A PVC pipe can be used to make the coupling due to its small diameter and strength. The PVC pipes are usually available at low cost and after installing, they do not require much maintenance.


The PVC pipe is very popular in Malaysia because of its light weight, strength and the fact that it can be used in any climate. It also does not require much investment in terms of labor cost, as it is usually made using the most basic material. However, when it comes to the installation, the cost gets escalated depending on the diameter and the length of the joint.


The PVC joints are usually made with various sizes of PVC pipe so that it can accommodate any given size pipe. Usually, the diameter of the joint is 4 feet when made with a single PVC pipe but if it is made with more than one pipe then it increases the size and hence the price. The PVC pipe is also available in different diameters depending on the need of the place and the climate. The diameter can be small or big according to the application. This makes the process of fitting a storm water drain system very complicated.


Before the camlock coupling is installed, it is necessary to have an accurate measurement of the pipe joint. This will help the contractor in getting the correct size of pipe. The cost of this service depends on the length and the diameter of the pipe. Most of the times, the contractor adds a few feet on the end of the joint. Sometimes, he might even add some inches on both ends so as to increase the price.


The contractors usually install the joint by cutting and welding two pieces of the pipe. This helps in increasing the life of the joint. If you have any concerns regarding where and ways to make use of please click the next post, you can contact us at the page. Once the joint is installed, they usually give a sandpaper free slip to the joint. This helps in reducing the friction and pressure on the joint. It also reduces the risk of rusting of the joint.


Storm water drainage systems usually have a number of connections made within the pipe. These connections are used for carrying water to different areas. Therefore, before the installation of the system, the right joints should be chosen. Sometimes, the installation depends on the type of the system. The best thing to do here is to contact your contractor and discuss the options that you have selected for your drainage system.